Are you connecting via serial port or via USB port.If you have a fairly new Signlab, there should be a SC650 driver in the Mutoh folder otherwise allmost any HPGL driver will make it cut.If you want USB, install the software on the Mutoh CD rom for the USB support. The CD from Mutoh will add a fake/new com port, usually com4 and will redirect output to com4 to the USB port.If cutting via serial, i would recommend setting Signlab and the cutter to at least 19200 baud rate instead of 9600 as that cutter cuts VERY VERY fast and may seem to pause alot at 9600.frank at cadlink.
» » CuttersThis table lists the manufacturers and cutters that are currently supported by ONYX. Select an individual manufacturer to see a list of specific cutters that are supported.
This advertisement does not exist anymore: Mutoh SC650 for sale Mutoh SC650 for sale. Machine is cutting very well. No software included. Max vinyl width: 750mm. This document or the contents herein under no circumstances shall be used in the manufacture or reproduction of the article shown and the delivery of this document shall not constitute any right or license to do so. 26 March 2009 Published: Mutoh Europe N.V., Archimedesstraat 13, B-8400 Oostende, BELGIUM 3 AP-75280 – Rev. 1.2 User’s Guide.